The World of my Cars

Picture of my interior when i was doing my wiring, that is my fuel pressure meter sitting on the floor carpet and the orange thing is my $8 walmart drill.




I did this as well , thermal wrapped the downpipe and a thermal kit for my turbo exhaust side to keep the heat low in my engine bay compartment. The lower the temp the higher the horsepower right =)




Oh before i wrapped it with thermal wrap I also ceramic coated it to withstand higher temp for the downpipe which is a 4" downpipe , HKS manifold , HKS wastegate and dumb tube.




My wiring done , although to you it's still quite a mess.




Almost there.




Wiring is hard job to do when the bay is so large and i'm so small , i literally have to lie down on my engine bay to solder each wire and make sure the connection is good.

I also bought some weatherproof electrical plugs to make disconnection easy and a breeze if i want to take out the upper manifold for modification next time around.




More wiring with turbo sitting there peacefully , and my bling bling oil inlet line. It was hard to cut those stainless steel hoses.




The journey begins to wire the Microtech engine harness into my car. It was such a pain man , seriously but its a nice experience to have when nobody is helping you out. Sighz